Filter
Top Products
92 Bridging Configuration
2. Active - Indicates whether the static route is active or not.
3. Ether Address -Enter the MAC address of the destination
device that you wish to bridge your packets to.
4. IP Address - If available, enter the IP address of the
destination device that you wish to bridge your packets to.
5. Gateway Node - Enter the number (1-4) of the Remote Node
that is linked to this static route. When an incoming packet’s
destination Ether (MAC) address matches the value entered
above, then it will trigger a call to this Remote Node.
Once you have completed filling in the menu, press ENTER at the
message: Press ENTER to Confirm ... to save your selections, or
press ESC at any time to cancel your selections.