Filter
Top Products
54 Remote Node Configuration
13. Bridge - Bridging is used for protocols that are not supported
or not turned on in the previous Route field by the Prestige,
e.g., SNA. When bridging is enabled, the Prestige will forward
any packet that it does not recognize to this Remote Node;
otherwise, the unrecognized packets are discarded. The
disadvantage of bridging is that it usually generates large
amounts of traffic. Press the space bar to select either Yes or
No.
14. Edit PPP Options - To edit the PPP options for this Remote
Node, move the cursor to this field, use the space bar to select
Yes and press ENTER. This will bring you to Menu 11.2 -
Remote Node PPP Options For more information on
configuring PPP options, see the section Editing PPP Options.
15. IP Addr - This is a required field if Route is set to IP. Enter the
IP address of this Remote Node.
16. Edit IP/IPX/Bridge Options - To edit the parameters of the
protocols, go to this field, select Yes and press ENTER. This
will bring you to Menu 11.3 - Remote Node Network Layer
Options. For more information on filling out this screen, refer to
the chapter pertaining to your specific protocol.
17. Telco Options: Transfer Rate - This field (which only applies
to outgoing calls) controls the rate at which the data is
transferred between your Prestige and the Remote Node. The
options for this field are:
• 64K - The Prestige will place 64Kbps (bits per second)
digital data calls.
(Default)
• Modem - The Prestige will place Modem data calls.
• X.75 - (for the DSS1 and 1TR6 only) The Prestige will
place X.75 digital data calls.
• V.120 - (for the DSS1 and 1TR6 only) The Prestige will
place V.120 digital calls.