Filter
Top Products
74 TCP/IP Configuration
used to resolve this problem by providing the Prestige with some
static routing information. As a matter of fact, when you configure
the Internet Access or a Remote Node, a static route is implicitly
created by the Prestige. An example is given below. In the
example, stations on the 204.5.1.0/24 subnetwork can access the
remote stations using the static route. The route will have a
destination of 204.5.1.64/26 with the gateway address being that of
the Remote Node (204.5.1.150).
Figure 7-4 Static Routing Example
Note that in normal circumstances, the Prestige will have adequate
routing information after you configure the Internet access and
Remote Nodes; you do not need to configure additional static
routes. You will need to configure static routes only for unusual
cases, e.g., subnetting. To create an additional static routes for IP,
use Menu 12, Static Route Setup as shown below: