Filter
Top Products
Chapter 25 Access Control
GS-3012/GS-3012F User’s Guide
178
Figure 96 Access Control: SNMP
The following table describes the labels in this screen.
25.3.4 Setting Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the switch via
web configurator at any one time.
1 An administrator is someone who can both view and configure switch changes. The
username for the administrator is always admin. The default administrator password is
1234.
" It is highly recommended that you change the default administrator password
("1234").
2 A non-administrator (username is something other than admin) is someone who can
view but not configure switch changes.
Table 65 Access Control: SNMP
LABEL DESCRIPTION
Get
Community
Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Set
Community
Enter the set community, which is the password for incoming Set- requests from the
management station.
Trap
Community
Enter the trap community, which is the password sent with each trap to the SNMP
manager.
Trap
Destination
Enter the IP addresses of up to four stations to send your SNMP traps to.
Apply Click Apply to save your changes to the switch’s run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.