Filter
Top Products
Chapter 32 Introducing the Commands
GS-3012/GS-3012F User’s Guide
235
name <port-name-
string>
Sets a name for your interface. Enter a
descriptive name (up to nine printable
ASCII characters).
13
no
bandwidth-limit
cir
Disables CIR bandwidth limits on the
port(s).
13
bandwidth-limit
egress
Disables egress bandwidth limits on the
port(s).
13
bandwidth-limit
pir
Disables PIR bandwidth limits on the
port(s).
13
broadcast-limit Disables broadcast storm control limit
on the port(s).
13
dlf-limit Disables destination lookup failure
(DLF) on the port(s).
13
egress set
<port-list>
Disables the outgoing traffic port list for
a port-based VLAN.
13
flow-control Disables flow control on the port(s). 13
gvrp Disables GVRP on the port(s). 13
igmp-filtering
profile
Disables IGMP filtering on the port. 13
igmp-group-
limited
Disables IGMP group limitation. 13
igmp-immediate-
leave
Disables IGMP immediate leave on the
port.
13
inactive Enables the specified interface on the
switch.
13
ingress-check Incoming traffic on the port(s) is not
checked for VLAN tags.
13
intrusion-lock Disables intrusion-lock on a port so that
a port can be connected again after you
disconnected the cable.
13
mirror Disables port mirroring on the port(s). 13
multicast-limit Disables multicast limit on the port(s). 13
vlan-trunking Disables VLAN trunking on the port(s). 13
pvid <1-4094> The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
13
qos priority <0 .. 7> Sets the quality of service priority for an
interface.
13
speed-duplex <auto|10-
half|10-
full|100-
half|100-
full|1000-full>
Sets the duplex mode (half, full) and
speed (10/100/1000 Mbps) of the
connection on the interface. Selecting
auto (auto-negotiation) makes one port
able to negotiate with a peer
automatically to obtain the connection
speed and duplex mode that both ends
support.
13
Table 85 Command Summary: Interface (continued)
COMMAND DESCRIPTION PRIVILEGE