Filter
Top Products
Chapter 32 Introducing the Commands
GS-3012/GS-3012F User’s Guide
233
32.10.5 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
ip address
inband-default
dhcp-bootp
Sets the default in-band interface to
use a static IP address in this VLAN.
The switch will use the default IP
address of 0.0.0.0 if you do not
configure a static IP address.
13
untagged <port-
list>
Specifies the port(s) you want to tag
all outgoing frames transmitted with
this VLAN Group ID.
13
normal <port-
list>
Specifies the port(s) to dynamically
join this VLAN group using GVRP
13
untagged
<port-list>
Specifies the port(s) you don’t want
to tag all outgoing frames transmitted
with this VLAN Group ID.
13
Table 84 Command Summary: config-vlan Commands (continued)
COMMAND DESCRIPTION PRIVILEGE
Table 85 Command Summary: Interface
COMMAND DESCRIPTION PRIVILEGE
interfac
e port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-limit Enables bandwidth limit on the switch. 13
cir Enables the guaranteed bandwidth
limits for incoming traffic on the port(s).
13
cir <Kbps> Sets the guaranteed bandwidth allowed
for incoming traffic on the port(s).
13
egress Enables bandwidth limits allowed for
outgoing traffic on the port(s).
13
egress <Kbps> Sets the maximum bandwidth allowed
for outgoing traffic on the port(s).
13
pir Enables bandwidth limits allowed for
incoming traffic on the port(s).
13
pir <Kbps> Sets the maximum bandwidth allowed
for incoming traffic on the port(s).
13
bpdu-control <peer|tunnel|di
scard|network>
Sets how Bridge Protocol Data Units
(BPDUs) are used in STP port states.
13
broadcast-limit Enables broadcast storm control limit on
the switch.
13
<pkt/s> Sets how many broadcast packets the
interface receives per second.
13
dlf-limit Enables the Destination Lookup Failure
(DLF) limit.
13
<pkt/s> Sets the interface DLF limit in packets
per second (pps).
13