Filter
Top Products
Chapter 3 Hardware Overview
GS-3012/GS-3012F User’s Guide
45
When auto-negotiation is turned on, a Gigabit port negotiates with the peer automatically to
determine the connection speed and duplex mode. If the peer Ethernet port does not support
auto-negotiation or turns off this feature, the switch determines the connection speed by
detecting the signal on the cable and using half duplex mode. When the switch’s auto-
negotiation is turned off, a Gigabit port uses the pre-configured speed and duplex mode when
making a connection, thus requiring you to make sure that the settings of the peer Ethernet port
are the same in order to connect.
3.1.2.1 Default Ethernet Negotiation Settings
The factory default negotiation settings for the Gigabit ports on the GS-3012 are:
• Speed: Auto
• Duplex: Auto
• Flow control: Off
• Link Aggregation: Disabled
The factory default negotiation settings for the Gigabit ports on the GS-3012F are:
• Speed: Auto
• Duplex: Auto
• Flow control: Off
• Link Aggregation: Disabled
3.1.2.2 Auto-crossover
All ports are auto-crossover, that is auto-MDIX ports (Media Dependent Interface Crossover),
so you may use either a straight-through Ethernet cable or crossover Ethernet cable for all
Gigabit port connections. Auto-crossover ports automatically sense whether they need to
function as crossover or straight ports, so crossover cables can connect both computers and
switches/hubs.
3.1.3 Mini-GBIC Slots
These are slots for mini-GBIC (Gigabit Interface Converter) transceivers. A transceiver is a
single unit that houses a transmitter and a receiver. The GS does not come with transceivers.
You must use transceivers that comply with the Small Form-factor Pluggable (SFP)
Transceiver MultiSource Agreement (MSA). See the SFF committee’s INF-8074i
specification Rev 1.0 for details.
You can change transceivers while the switch is operating. You can use different transceivers
to connect to Ethernet switches with different types of fiber-optic connectors.
1 To avoid possible eye injury, do not look into an operating fiber-optic module’s
connectors.
• Type: SFP connection interface
• Connection speed: 1 Gigabit per second (Gbps)