Filter
Top Products
Chapter 5 Universal Repeater Mode
WAP3205 User’s Guide
41
5.6.3 WPA(2)-PSK
Figure 24 Universal Repeater Mode: Wireless LAN > Universal Repeater: WPA(2)-PSK
The following table describes the labels in this screen.
WEP Key 1 ~
WEP Key 4
The WEP keys are used to encrypt data. Both the WAP3205 and the access point
must use the same WEP key for data transmission.
If you chose HEX, enter 10 or 26 hexadecimal characters in the range of "A-F",
"a-f" and "0-9" (for example, 11AA22BB33) for a 64-bit or 128-bit WEP key
respectively.
If you chose ASCII, enter any 5 or 13 ASCII characters (case sensitive) ranging
from "a-z", "A-Z" and "0-9" (for example, MyKey) for a 64-bit or 128-bit WEP key
respectively.
You must configure at least one key, only one key can be activated at any one
time.
Apply Click Apply to save your changes back to the WAP3205.
Reset Click Reset to reload the previous configuration for this screen.
Table 16 Universal Repeater Mode: Wireless LAN > Universal Repeater: Static WEP
LABEL DESCRIPTION
Table 17 Universal Repeater Mode: Wireless LAN > Universal Repeater: WPA(2)-PSK
LABEL DESCRIPTION
Universal Repeater Parameters
Enable Select this option to have the WAP3205 connect to the specified access point.
SSID Enter the name of the access point to which you are connecting.
MAC Address
(Optional)
Enter the MAC address of the access point to which you are connecting.
Security Mode Select WPA-PSK or WPA2-PSK if the access point to which you want to connect
uses WPA-PSK or WPA2-PSK.
Encryption Type Select the type of wireless encryption employed by the access point to which you
want to connect.
Pre-Shared Key WPA-PSK or WPA2-PSK uses a simple common password for authentication.
Type the password employed by the access point to which you want to connect.
Apply Click Apply to save your changes back to the WAP3205.
Reset Click Reset to reload the previous configuration for this screen.