A SERVICE OF

logo

504 Chapter 6
Command Definitions P-R
RESUMELOG
RESUMELOG
Resumes system logging following suspension caused by an error. (Native Mode)
Syntax
RESUMELOG
Parameters
None.
Operation Notes
When the operator resumes logging with the RESUMELOG command, a special log record is
displayed that denotes the number of log events and corresponding records that were not
recorded while logging was suspended, the total number of unrecorded job initiation
records, and the total number of unrecorded job/session termination records.
Use
This command may be issued from a session, job, program, or in BREAK. It may be
executed only from the console, or by a user with system supervisor (OP) capability.
Examples
Assume the system is online and running with logging enabled. If a recoverable error
occurs, the following error message is sent to the system console:
ST/10:43/LOG FILE NUMBER 104 ERROR #46.
LOGGING SUSPENDED.
After the error is corrected, enter RESUMELOG. A confirmation message then appears at the
system console, as follows:
ST/10:45/LOG FILE NUMBER 104. LOGGING RESUMED.
ST/10:45/LOG FILE NUMBER 104 ON.
Related Information
Commands ALTLOG, CHANGELOG, GETLOG, LISTLOG, LOG, OPENLOG, RELLOG,
SHOWLOGSTATUS, SWITCHLOG,
Manuals System Startup, Configuration, and Shutdown Reference Manual