Filter
Top Products
1-4 CHAPTER 1: OVERVIEW
NETBuilder II Systems
with a CEC 20 Module
Use the following checklist to install system software, boot the system, and
configure basic settings on a NETBuilder II system that has a CEC 20 module.
Install System Software and Boot — Refer to Chapter 4
Change the Primary Boot Source — Refer to Chapter 5
Configure Specific Services for Your Network — Refer to Using NETBuilder
Family Software and Reference for NETBuilder Family Software.
❑
Select an installation option and proceed to appropriate installation section:
❑
Install software from flash memory card and boot the system.
or
❑
Install software from CD-ROM on UNIX or PC-based network management
station and boot the system.
❑ Change the primary boot source default as needed.
Configure Basic Settings — Refer to Chapter 6
❑ Log on to the system.
❑ Familiarize yourself with the command-line or menu-driven user interface (UI),
storing configuration parameter values, and getting help.
❑ Obtain Network Manager privilege level.
❑ Change the Network Manager password.
❑ Adjust the time and date if necessary. Time and date are preset and may need
to be adjusted for your time zone.
❑ Set system administrator information:
❑ System name
❑ System location
❑ System contact name and phone number
❑ Assign IP addresses/subnet masks to individual ports or one address to
the system.
❑ Set up the bridge/router for SNMP.
❑ Set up NETBuilder security.
❑ Use the Quick Installation Utility for further configuration.