Filter
Top Products
5-2 CHAPTER 5: CHANGING THE BOOT SOURCE ON A CEC 20 SYSTEM
If the bridge/router is unable to boot, enter Y at the monitor prompt, as shown in
this screen display.
3Com Corporation NETBuilder II power-on
FW/NBII-FW,2.6
CEC*: 8 Mbytes IMEM, 8 Mbytes DMEM, 4 Mbytes SMEM
Booting from drive A ...
File - BOOT.29K - not found
Do you want to enter the monitor? (y/n) : y
3Com Corporation NETBuilder II Monitor
>
4 Access the System Configuration menu by typing SF at the NETBuilder command
prompt or in the firmware monitor.
Information similar to the following is displayed:
5 Enter 3 to select Start-Up Action.
Information similar to the following is displayed:
6 Enter 4 to select Try boot forever.
Information similar to the following is displayed:
7 Press the Return key to confirm.
Information similar to the following is displayed:
Updating EEPROM. Please wait . . .
System Configuration
1. Serial Ports Console: 9600 Auxiliary: 9600
2. Self-Test Skip
3. Start-Up Action Try boot once
4. Primary Boot Source Drive A:
5. Secondary Boot Source Local: Drive A:
6. Test Boot Source Unknown boot source Slot: 0
7. Boot Sources Primary and Secondary
8. Dump Destination Do not dump
9. Recovery Procedure
10. MP Boot Source
11. Boot Statistics Booted: 7 Exceptions: 3
Enter parameter number or press Q to quit:
Start-Up Action: Try boot once
1. Enter monitor
2. Local
3. Try boot once
4. Try boot forever
Choose Start-Up Action or press Q to quit (CR=Try boot once):
Start-Up Action: Try boot forever
1. Enter monitor
2. Local
3. Try boot once
4. Try boot forever
Choose Start-Up Action or press Q to quit (CR=Try boot forever):
System Configuration
1. Serial Ports Console: 9600 Auxiliary: 9600
2. Self-Test Skip
3. Start-Up Action Try boot forever
4. Primary Boot Source Drive A
5. Secondary Boot Source Local: Drive A:
6. Test Boot Source Unknown boot source Slot: 0
7. Boot Sources Primary and Secondary