Filter
Top Products
6-24 CHAPTER 6: CONFIGURING BASIC SETTINGS
Security Commands and
Parameters
To make sure that some designated files are accessible only to the system
administrator, use the following commands and parameters:
■ NetAccess
This parameter is a SYS Service parameter that determines how a
bridge/router can be accessed from another device on the network. For
information on how to use the NetAccess parameter, refer to Using
NETBuilder Family Software and to Reference for NETBuilder Family Software.
■ SysPassWord
This command brings up a menu allowing you to specify the password for
the Network Manager and User privilege levels. For information on how to
use the SysPassWord command, refer Reference for NETBuilder Family
Software.
■ RemoteManager
This parameter is a SYS Service parameter that specifies the Internet
addresses of devices that can connect to the bridge/router through the
REMote command. For information on how to use the RemoteManager
parameter, refer to Using NETBuilder Family Software and to Reference for
NETBuilder Family Software.
■ COMmunity
This parameter is an SNMP Service parameter that modifies the list of
communities. For information on how to use the COMmunity parameter,
refer to Using NETBuilder Family Software and to Reference for NETBuilder
Family Software.
What Next? You are now ready to refer to Using NETBuilder Family Software to configure your
bridge/router for your specific network needs.