Filter
Top Products
Configuring the Primary Boot Source 5-3
Enter 4 to select Primary Boot Source.
Information similar to the following is displayed:
8 Enter 1 to select Boot Device.
Information similar to the following is displayed:
Primary Boot Device:
Local: Drive A:
1. Local
2. Network
Choose Primary Boot Device or press Q to quit:
9 Enter 2 to select Network.
Information similar to the following is displayed:
Network Boot:
Choose a slot :
10 Enter the slot number where the CEC 20 is installed.
For example, type 7 to specify slot 7.
Information similar to the following is displayed:
Boot Filename: boot.29k
Enter Boot Filename (CR=no change):
11 Select the NETBuilder bridge/router software version 10.1 as the default boot
source file by entering:
/primary/boot.29k
Information similar to the following is displayed:
Primary Boot Device:
Network: Slot 7: /primary/boot.29k
1. Local
2. Network
Choose Primary Boot Device or press Q to quit:
8. Dump Destination Do not dump
9. Recovery Procedure
10. MP Boot Source
11. Boot Statistics Booted: 7 Exceptions: 3
Enter parameter number or press Q to quit:
Primary Boot Source:
1. Boot Device: Drive A:
2. Default file source Local:
3. Maximum retries 0
4. I/O Module Parameters Ethernet
5. Boot Protocol TFTP Local configured addresses
6. IP Addresses client:none
Subnet Mask:none
7. MAC Address System 08-00-02-05-1A-BE
8. ARP Format Canonical
9. FTP Login Parameters
Enter parameter number or press Q to quit: