Filter
Top Products
iv
Booting a Component NETBuilder II System 4-2
Installing Software from a Network Management Station 4-2
Setting Up the
UNIX-based Network Management Station 4-2
Prerequisites 4-2
Procedure 4-3
Setting Up the PC-based Network Management Station 4-5
Prerequisites 4-5
Procedure 4-5
Booting a
NETBuilder II Image over the Network 4-6
Procedure 4-7
Copying the Software to a Flash Memory Card 4-8
Configuring IP 4-8
Copying Software to the NETBuilder II Using TFTP 4-9
5
C
HANGING
THE
B
OOT
S
OURCE
ON
A
CEC 20 S
YSTEM
Configuring the Primary Boot Source 5-1
Prerequisites 5-1
Procedure 5-1
6
C
ONFIGURING
B
ASIC
S
ETTINGS
Logging on to the System 6-1
Learning About the User Interface 6-2
Accessing the User Interface 6-2
Menu-Driven Versus Command-Line Interface 6-2
Using the Menu-Driven Interface 6-2
Using the Command-Line Interface 6-3
Full-Form Syntax 6-4
Abbreviated Syntax 6-5
Symbols 6-5
Full and Abbreviated Syntax Examples 6-6
Variations in Command Syntax 6-7
Entering Service Names in Command Lines 6-7
Determining the Display of Ports and Virtual Ports 6-7
Using Aliases 6-8
Command History Substitution 6-8
Privilege Level 6-9
Command-Line Parameter Attributes 6-9
Syntax for Assigning Values 6-10
Numeric Values 6-10
Names 6-10
Strings 6-10
Port and Path Naming Restrictions 6-11
ISDN-Related Syntax Variation 6-11
Address Formats 6-12
Media Addresses 6-12
Network Layer Addresses 6-14
Getting Help 6-16
Setting up IP Routing 6-16