Filter
Top Products
4-8 CHAPTER 4: INSTALLING SOFTWARE AND BOOTING A CEC 20 NETBUILDER II SYSTEM
14 Enter Q repeatedly to return to the System Configuration menu.
15 Ensure that Boot Sources is set to Primary and Secondary.
If Boot Sources is not set correctly, follow these steps:
a From the System Configuration menu, enter 7.
b From the Boot Sources menu, enter 2.
16 Exit the menu system by typing Q repeatedly.
17 To boot the software image from the network management station, enter:
NB
The bridge/router obtains its software image from the network management
station and boots.
When the following message is displayed:
System Initialized and Running
the bridge/router has finished booting.
Copying the Software
to a Flash Memory
Card
To boot locally, the software image boot file must be copied to the flash memory
card in drive A.
Configuring IP Before you copy the software to the NETBuilder II bridge/router flash memory
card, you must configure IP for the port that the NETBuilder II bridge/router can be
accessed through.
This procedure assumes that you have just booted the NETBuilder bridge/router
over the network.
To configure IP on the NETBuilder II bridge/router, follow these steps:
1 Press the Return key.
The following prompt is displayed on the console:
NetLogin:
2 Log on as root:
root
3 Press the Return key.
Pressing the Return key when prompted for the password enters a null string,
which is the default local password.
The bridge/router system prompt is displayed:
NETBuilder #
You are now ready to begin using the software and entering software commands.
4 Set up an IP address and subnet mask using:
SETDefault !<port> -IP NETaddr = <IP address> [<subnet mask>]
For more information on IP configuration, refer to Reference for NETBuilder Family
Software.
5 Enable IP routing by entering:
SETDefault -IP CONTrol = RO