Filter
Top Products
DUA1840-0AAA01
Accessing the Switch 1005 VT100 Interface
2-17
Switch 1005 Management Setup
The Switch Management Setup screen allows you to configure IP and
IPX parameters for the Switch 1005. This screen also allows you to
display a screen for setting up traps.
If you change the IP parameters using this screen, the changes will not
take effect until you reset the Switch 1005. Refer to
“Resetting the
Switch 1005”
in Chapter 3.
To access the Setup screen, from the Switch Main Menu screen, select
the MANAGEMENT SETUP option. The Setup screen appears as shown
in
Figure 2-5
.
Figure 2-5
Switch Management Setup screen
The screen shows the following:
MAC Address
The Switch 1005 MAC address required for
management.
Power On Self Test (POST) Type
Normal/Extended
Use this field to
determine the type of self-test that the Switch 1005 carries out when it
is powered up. If this field is set to
Normal
, a basic confidence check
lasting approximately 10 seconds is carried out. If this field is set to
Extended
, a full set of tests are carried out which may take up to 90
seconds to complete.