3Com 100 TX Switch User Manual


 
FCC CLASS A VERIFICATION STATEMENT
WARNING: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules, and the Canadian Department of Communications Equipment Standards entitled, “Digital Apparatus,” ICES-003. These limits are
designed to provide reasonable protection against harmful interference in a commercial installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case, the user will be
required to correct the interference at the user’s own expense.
Changes or modifications not expressly approved by 3Com could void the user’s authority to operate this equipment.
CISPR A COMPLIANCE
This device complies with the EMC directive of the European Community and meets or exceeds the following technical standard:
EN 55022 – Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equipment.
This device complies with the CISPR Class A standard.
WARNING: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
3Com Corporation
5400 Bayfront Plaza
Santa Clara, CA 95052-8145
(408) 764-5000
CE NOTICE
Marking by the symbol indicates compliance of this equipment to the EMC directive of the European Community. Such marking is
indicative that this equipment meets or exceeds the following technical standards:
EN 55022—“Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equiment.”
EN 50082-1—“Electromagnetic compatibility —Generic immunity standard Part 1: Residential, commercial, and light industry.”
IEC 801-2—“Electromagnetic compatibility for industrial-process measurement and control equipment Part 2: Electrostatic discharge
requirements.”—Severity level 3.
IEC 801-3—“Electromagnetic compatibility for industrial-process measurement and control equipment Part 3: Radiated electromagnetic field
requirements.”—Severity level 2.
IEC 801-4—“Electromagnetic compatibility for industrial-process measurement and control equipment Part 4: Electrical fast transient/burst
requirements.”—Severity level 2.
A “Declaration of Conformity” in accordance with the above standards has been made and is on file at 3Com Corporation.