Filter
Top Products
97
4 If the drive bay is covered by a metal EMI shield, insert your finger
in the large hole in one end of the shield and pull the shield from
the chassis. Save the shield.
5 If the drive bay has an existing drive installed, remove the drive
(see page 96) and remove the slide rails attached to the sides of
the drive. Save the rails and screws.
6 Remove the new drive from its protective wrapper and place it on
an antistatic surface.
7 Record the new drive model and serial numbers in your equipment
log.
For a sample equipment log sheet, refer to page 195.
8 Set any jumpers or switches on the new drive according to the
drive manufacturer instructions.
9 Attach a slide rail to each side of the drive using two mounting
screws.
10 Position the drive so the plastic slide rails engage the guide rails in
the peripheral bay. Push the drive into the bay until the slide rails
lock in place.
11 Connect the signal and power cables to the drive. You can insert
the keyed connectors only one way.
12 Install the foam fan baffle, fan modules, and the front access
panel.
BB!H:11!vh!.!FO/cppl!!Qbhf!:8!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN