Filter
Top Products
3 Hardware configuration
106
To install the foam fan baffle
1 Position the fan baffle so the holes in the bottom of the baffle are
aligned with the four hot swap drive bay mounting screws (or
holes) in the front subchassis.
2 Gently bend back the ends of the foam baffle (Figure 54, A), then
push down and slide the baffle straight into the chassis until the
tabs on the front subchassis mate with the corresponding notches
in the baffle.
3 Install the fan distribution board.
4 Install the fan modules.
5 Install the front access panel.
BB!H:11!vh!.!FO/cppl!!Qbhf!217!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN