Acer G901 Server User Manual


 
47
Front subchassis and rear
electronics bay
The server chassis consists of three parts, which include the following:
Main chassis
Front subchassis (sometimes called the C-tilt)
Rear electronics bay
Both the front subchassis and the rear electronics bay swing open.
Additionally, you can completely remove them to gain access to the
server’s internal components. You can more easily open and remove
the front subchassis and electronics bay if the system is laying on its
side (rack-mount orientation).
Opening the front subchassis and rear
electronics bay
The front subchassis must be opened slightly to allow the rear
electronics bay to open because the front subchassis overlaps the rear
electronics bay.
To open the front subchassis and rear electronics bay
1 Remove the front and rear access covers (refer to page 46 and
page 44).
2 To open the front subchassis, grasp the edge of the bezel and
swing the front subchassis out until the spring clip at the top of
the subchassis just springs open.
3 To open the rear electronics bay:
a Disconnect all cables attached to the mainboard.
b Grasp the inside edge of the electronics bay and swing the
electronics bay out from the main chassis.
BB!H:11!vh!.!FO/cppl!!Qbhf!58!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN