Filter
Top Products
4 BIOS setup
112
To clear the CMOS memory using the front panel buttons
1 Power down the server.
2 Press the Reset button and hold it down for four seconds or more;
while holding down the reset button, press the power button.
3 Release both buttons at the same time.
To clear the CMOS memory using CMOS Clear jumper
1 Power down the server.
2 Install a jumper on the CMOS Clear jumper pins.
3 Boot the system.
4 Power down the system and remove the jumper from the CMOS
Clear pins.
The next time the system is started following the CMOS clear, the boot
process halts displaying the message NVRAM cleared by jumper.
Using BIOS setup
To run BIOS setup, boot the server and press the F2 key when
prompted.
Use the keys listed in the table below to navigate through the BIOS
setup menus.
Press: To:
F1 or Alt+H Get general help
® Move between menus
- Go to the previous item
¯ Go to the next item
+ or - Change the value of an item
Enter Select an item or display a submenu
Esc Leave a submenu or exit BIOS setup
BB!H:11!vh!.!FO/cppl!!Qbhf!223!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN