Acer G901 Server User Manual


 
65
5 Following the instructions packaged with the applicator, apply
thermal grease to the processor.
6 Insert the heat sink (Figure 30, A) into the air baffle and place it on
top of the processor.
7 Install both heat sink retention clips (Figure 30, D) as follows:
a Place the heat sink clip on the center tab of the retention
module and slide the clip to the right to engage the center
tab.
b Snap one end of the clip down over the corresponding tab on
the retention module (Figure 30, C).
c Snap the remaining end of the clip down over the
corresponding tab.
To remove processors
Caution! A microprocessor and heat sink may be hot if the
system has been running. Also, there may be sharp pins and edges
on some board and chassis parts. Contact should be made with
care. Consider wearing protective gloves.
Figure 30 - Installing the heatsink
BB!H:11!vh!.!FO/cppl!!Qbhf!76!!Gsjebz-!Kbovbsz!28-!3114!!8;24!QN