Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7132
1U Rackmount System
Unpacking
The motherboard is shipped in antistatic packaging to avoid electrical static dis- charge. When unpacking
the board, make sure the person handling it is static protected.
5-2 Serverboard Installation
This section explains the first step of physically mounting the embedded board into the RMC7132 chassis.
Following the steps in the order given will eliminate the most common problems encountered in such an
installation. To remove the motherboard, follow the procedure in reverse order.
Installing to the Chassis
1. Access the inside of the system by removing the screws from the back lip of the top cover of the chas-
sis, then pull the cover off.
2. The embedded board requires a chassis big enough to support a 12" x 9.6" serverboard.
3. Make sure that the I/O ports on the serverboard align properly with their respective holes in the I/O
shield at the back of the chassis.
4. Carefully mount the serverboard to the serverboard tray by aligning the board holes with the raised
metal standoffs that are visible in the chassis.
5. Insert screws into all the mounting holes on your serverboard that line up with the standoffs and tighten
until snug (if you screw them in too tight, you might strip the threads). Metal screws provide an electrical
contact to the serverboard ground to provide a continuous ground for the system.
6. Finish by replacing the top cover of the chassis.
Warning: To avoid damaging the motherboard and its components, do not apply any force greater than 8
lbs. per square inch when installing a screw into a mount- ing hole.