Filter
Top Products
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218
© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
RMC 7132
1U Rackmount System
6-5 Power Supply
The Acnodes RMC7132 has a single 200 watt power supply. This power supply has the capability of
operating at 100 - 240 input volts. Power down the system and then unplug the AC power cord to
completely remove power from the system before removing the power supply.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to replace the power supply
unit. Replacement units can be ordered directly from Acnodes(PWS-201-1H - see contact infomation
in Chapter 1).
Replacing the Power Supply
1. Power down the system (if on) and unplug the power cord.
2. Grasp the two handles on either side and pull the unit straight out until it locks (you will hear a
"click").
3. Depress the two buttons on the top of the chassis to release the top cover
and push it away from you. You can then lift the top cover from the chassis to gain full access to the
inside of the server.
4. To remove the failed power unit, remove the two screws on the back of the power supply and a
third from the front of the power supply, which secures it to the bottom of the chassis. You can then lift
the unit straight out of the chassis.
5. Replace the failed unit with another unit of the same wattage. It is highly recommended to replace
it with the exact same power supply.
6. Carefully insert the new unit into position in the chassis and secure it with the two screws at the
rear of the unit and the third at the front.
7. Reconnect the power cord, replace the chassis top cover and push the unit back into the rack.
8. Finish by depressing the power button on the front of the system