Filter
Top Products
Configure and View Status
40 Megabit Modem CRA-C User Manual
Reset the Ethernet Bridge
Changes you make to the Ethernet bridge through the Bridge/Router
Configuration menus (pages 31 and 37) and SNMP Configuration menu
(page 38) write immediately to flash memory when changes are confirmed.
However, they do not take effect until the Megabit Modem CRA-C Ethernet
bridge is reset. The Reset option causes the bridge to reboot with the new
configuration.
Reset the Megabit Modem CRA-C Ethernet bridge:
1 Type
at the Main Menu to display the Bridge/Router menu.
07/02/97 PAIRGAIN TECHNOLOGIES 08:55:55
ATU-C ADSL MEGABIT MODEM TERMINAL 01.01
BRIDGE/ROUTER MENU
-----------------------------------------------------------
ETHERNET MAC ADDRESS: 00-20-A7-20-68-F2
10 BASE-T LINK STATUS: LINK UP
EBM STATUS: READY
-----------------------------------------------------------
SELECTIONS 1. BRIDGE/ROUTER CONFIGURATION
2. SNMP CONFIGURATION
3. STATISTICS
-----------------------------------------------------------
SETTINGS 4. RESET
(M)ain
ENTER CHOICE-->
WARNING: This will bring down all connections. Are you sure? (Y/N)
2 Make all changes in the Bridge/Routing Configuration menu and
the SNMP Configuration menu.
3 Type
to select Reset.
4 Type either Y for yes to Reset or N for no to cancel Reset.
When you select Y to Reset, the Megabit Modem CRA-C Ethernet link is
dropped, the bridge is reset, then the Ethernet link is re-established. The
changes made to the Ethernet bridge are now effective.