Filter
Top Products
September 25, 2006 Chapter 3: Provisioning
LTPE-UM-3159-02 3-11
SNMP Parameters Menu
In the Config menu, press S to display the SNMP Parameters menu (Figure 3-6). This menu is used to configure the
EMU-830 for operation with SNMP (ignore this section if you are not using SNMP). The SNMP Parameters menu
options are listed in Table 3-6 on page 3-12.
Figure 3-6. SNMP Parameters Menu
Local SLIP Subnet Mask Allows the EMU-830 to determine if a host (TFTP
server, SNMP management station, or trap receiver)
is on the same local subnet. If it is, the EMU-830 can
communicate directly with the host; if it is not,
messages must be sent through a default router.
0.0.0.0 is the default setting.
SLIP Port Baud Rate Select the SLIP Port baud rate by toggling to the
desired rate (maximum 19200 bps).
BOOTP Server IP
Address
Enter the IP address for the BOOTP server to which
the EMU-830 is connected. 0.0.0.0 is the default
setting. This information is only required if using the
BOOTP protocol.
BOOTP Gateway IP
Address
Enter the IP address for the gateway for the BOOTP
server. 0.0.0.0 is the default setting. This information
is only required if using the BOOTP protocol and the
BOOTP server is connected through a gateway.
Boot Mode Select the Boot Mode by toggling between NVRAM
(the default) or NETWORK. BootP/TFTP Server can
be used for uploading software using the Network.
Option Function