ADTRAN MX2800 M13 Network Card User Manual


 
MX2800 M13 Multiplexer User Manual Transaction Language 1 (TL1), Section 9
61200290L1-1G 9-11
* An asterisk indicates optional command blocks.
TL1 Autonomous Messages
Autonomous messages provide a mechanism for real time reporting of system events. Although most
events reported are alarms, some events are only informational. The Verb, Mod1, and Mod2 parameters of
the message indicate what type of event has occurred.
NOTE
The default setting for Autonomous message reporting is OFF.
Follow these steps to enable Autonomous message reporting:
If it has not already been done, initiate a TL1 session by following the setup procedures and using the
ACT-USER command.
Use the ALW-MSG command to enable autonomous messaging. This command is described in
Table 9-2 on page 9-6.
REPT-ALM
indicates an alarm event. Table 9-3 on page 9-12 lists possible autonomous messages for
alarm events and includes recommended actions to take. REPT-EVT indicates an informational event.
Table 9-4 on page 9-16 lists possible autonomous messages for informational events
SET-DAT:<tid>::<ctag>::<YY-MM-DD>,<HH-MM-SS>;
Description Sets the date and time
PARAM1 Date in YY-MM-DD format
PARAM2 Time in HH-MM-SS format
Table 9-2. TL1 Commands (Continued)