Filter
Top Products
MX2800 M13 Multiplexer User Manual Configuration, Section 3
61200290L1-1G 3-3
Figure 3-2. Configuration Menu Tree
Network Interface
T1/E1 Interface
Utilities
M13
C-BIT*
Local
Loop*
Shutdown Standby
Loopback Time Out
B
A
Enabled
Disabled*
Enabled
Auto Enable*
Disabled
CSU
NIU
Disabled*
Save Configuration & Alarm Log
State
T1 # 1-28
T1 # 1-28
T1 # 1-28
T1 # 1-28
Loopback Detection
Line Coding
Timing
Remote Loopbacks
Framing
XCV Threshold
Circuit Protection
Line Identification
XCV Threshold
B8ZS*
AMI
FEAC/C-BIT*
FEAC
C-BIT
Disabled
IE-3
IE-4
IE-5
Disabled*
IE-6
IE-3
IE-4
IE-5
Disabled*
IE-6
Equipment Identification
Syslog Setup
Auto Save
Alarm Relay Configuration
Craft baud rate
Server IP Address
Refresh Period
DST Automatic Adjustment
State
Local Time Zone
1 min.
5 min.*
10 min.
Disabled
15 min.
30 min.
45 min.
1 hour
Line Length
DS3 Configuration
Protection Configuration
DS2 Configuration
DS2 1-7
Miscellaneous
Active Controller
Max Switch Threshold (3)*
Network Protection
Min Switch Period (10)*
System Management
Mgmt Options
System Security
Date & Time
Miscellaneous
SNMP Mgmt Options
Trap IP Address
Write Community Name
Trap Generation
Trap Community Name
SNMP State
Read Community Name
Controller Traps
DS2 Alarm Traps
Power Supply Alarm Traps
T1/E1 Alarm Traps
MIB II Standard Alarm Traps
DS3 Alarm Traps
Radius State
Privilege Level
Server IP Address
Shared Secret Visibility
Shared Secret
UDP Port
Local IP Address
Gateway IP Address
Subnet Mask
Forward IP to Remote DS3
DS3 Remote IP Address
DS3 IP MTU
Dialup Options (List 1)
Management Port
Modem Rmt IP Addr (List 1)
Load Default Settings
System Reset
Update FLASH Software
Configuration Transfer
133-266 ft.
266-399 ft.
399-533 ft.
0-133 ft.*
533-655 ft.
Enabled*
Disabled
Local User Accounts
Radius Mgmt options
Time
Date
T1 # 1-28
T1 # 1-28
Update via TFTP Server
Update via XMODEM
Terminal Timeout
User Account Management
IP Hosts
IP Security
* = default settings
Network Date/ Time Options
Load Default settings OTHER THAN system management
Load SYSTEM MANAGEMENT default settings
Load ALL default settings
Auto Enable Delay
Maximum Retries
Response Timeout
System Name