ADTRAN 600R Network Router User Manual


 
Page 38 © 2002, ADTRAN, Inc. 64200600L1#T-31A
Total Access 600R User Interface Guide (UIG)
ROUTER>CONFIG>ETHERNET
Use the E
THERNET
menu (Figure 8) to configure the Ethernet port on the 600R.
Figure 8. Ethernet Menu
ROUTER>CONFIG>ETHERNET>PRIMARY IP
This is used to setup the IP address for the LAN on the 600R.
IP Address
The IP address assigned to the 600R's Ethernet port is set here. This address must be unique within the
network. Default is
10.0.0.1
.
Subnet Mask
This is the IP network mask that is to be applied to the 600R's Ethernet port. Default is
255.255.255.0
.
Default Gateway
The default gateway is used by the 600R to send IP packets whose destination address is not found in
the route table. Default is
0.0.0.0
.
RIP
Use this menu to enable RIP on the LAN interface.
TCP ESTAB
Yes - only when TCP established
No - only when TCP not established
Ignore - ignore TCP flags (default)