Filter
Top Products
Page 44 © 2002, ADTRAN, Inc. 64200600L1#T-31A
Total Access 600R User Interface Guide (UIG)
R
OUTE
The IP parameters are configured in this menu. For unnumbered interfaces, the Total Access 600R
will automatically discover the PPP peer’s networks using PPP IPCP and/or RIP.
RIP
Use this menu to enable RIP on the WAN interface.
S
ERVER
P
ORT
This option is only available when
NAT P
ORT
T
RANSLATION
is
enabled. This is the port used on the public side.
TIME
This option is only available when
NAT PORT TRANSLATION
is
enabled. This is the time since the entry was last used.
I
N
C
NT
This option is only available when
NAT P
ORT
T
RANSLATION
is
enabled. This is the number of packets that came in.
O
UT
C
NT
This option is only available when
NAT PORT TRANSLATION
is
enabled. This is the number of packets sent out.
NAPT ADDRESS
This option is only available when
NAT P
ORT
T
RANSLATION
is
enabled. Represents the public address that is being used as the
NAPT address. Read-only.
E
NTRY
C
OUNT
This option is only available when
NAT P
ORT
T
RANSLATION
is
enabled. The number of entries in the NAT table. Maximum is
1500.
E
NTRY
O
VERFLOW
C
OUNT
This option is only available when
NAT PORT TRANSLATION
is
enabled. A count of the dropped entries due to entry count being
1500 or greater; i.e., the NAT table is full.
FAR-END IP/NET
The PPP peer’s IP address or network can be set here, if known.
Leaving this at 0.0.0.0 means that the Total Access 600R will de-
termine the PPP peer’s IP and network (if unnumbered) using
the PPP IPCP. Default is
0.0.0.0
.
N
ETMASK
This network mask is applied to the IP/NET address for
determining the PPP peer’s network. If left as 0.0.0.0, a
standard network mask is used. Default is 0.0.0.0.
S
TATIC
R
OUTE
Selecting Y
ES
will add a static route to the remote peer to
the route table. Default is Y
ES
.
PRIVATE
Selecting Y
ES
will prevent this route from being adver-
tised. Default is N
O
.
H
OPS
(1-16)
This value is the metric or number of hops that RIP will
use in advertising the static route. The range is 1 to 16,
where 1 is the default. The value 16 is considered an infi-
nite distance in RIP and is, in effect, poisoning the route.
F
ORCE
IP
When set to Y
ES
, the 600R will force the PPP peer to use
the IP address in the IP/Net for this profile as its WAN IP
address. Normally this is set in the N
O
position. Default is
N
O
.
L
OCAL
IP
This is the IP address that is assigned to the PPP link when
using numbered links. By default, no address is assigned
and the PPP link is unnumbered. Default is 0.0.0.0.