Filter
Top Products
Page 72 © 2002, ADTRAN, Inc. 64200600L1#T-31A
Total Access 600R User Interface Guide (UIG)
Appendix B. Configuring the Total Access 600R for Bridging
Initial Setup
Before the Total Access 600R can be configured for bridging, DS0s must be mapped. (See DS0 Mapping on page 66).
Setting up Bridging Options
If the Total Access 600R will be used for bridging, continue with the steps below.
Bridging
There are two steps required for the Total Access 600R to be used for Bridging: (1) Global Bridging Setup and (2)
WAN Bridging Setup. Both of these procedures are described on the pages that follow.
Global Bridging Setup
WAN Bridging Setup
Choose one of the following options: PPP Bridge Setup or Frame Relay Bridge Setup. Both of these procedures are
described on the pages that follow.
Global Bridging Setup Instructions
Step Action
1
From the Main Menu, select
R
OUTER
, select
C
ONFIG
, and then select
G
LOBAL
.
2
Press
Enter
on the
B
RIDGE [+]
option.
3 Set the M
ODE
to O
N
. Return to the main G
LOBAL
menu.
4 Press Enter on the IP [+] option.
5 Set the M
ODE to OFF
.
6
Return to the main menu. Confirm all configuration changes with “y” for
yes.
WAN Bridging - PPP Bridge Setup Instructions
Step Action
1
From the Main Menu, select R
OUTER
, select C
ONFIG
, and then select
WAN.
2 Set the L2 P
ROTOCOL
to PPP.
3 Press Enter on the PPP P
ROFILE
[+] option.
4 Press Enter on the B
RIDGE
[+] option.
5 Set the M
ODE
to O
N
.
6 Return to the main PPP P
ROFILE
[+] menu.