Agilent Technologies 66332A Power Supply User Manual


 
4 - Language Dictionary
62
STATus:OPERation:ENABle
This command and its query set and read the value of the Operational Enable register. This register is a
mask for enabling specific bits from the Operation Event register to set the operation summary bit (OPER)
of the Status Byte register. This bit (bit 7) is the logical OR of all the Operatonal Event register bits that are
enabled by the Status Operation Enable register.
Command Syntax
STATus:OPERation:ENABle<NRf>
Parameters
0 to 32727
Preset Value
0
Examples
STAT:OPER:ENAB 1312STAT:OPER:ENAB 1
STATUS:OPERATION:ENABLE?
Query Syntax
STATus:OPERation:ENABle?
Returned Parameters
<NR1> (register value)
Related Commands
STAT:OPER:EVEN
STATus:OPERation:NTR
STATus:OPERation:PTR
These commands set or read the value of the Operation NTR (Negative-Transition) and PTR (Positive-
Transistion) registers. These registers serve as polarity filters between the Operation Enable and
Operation Event registers to cause the following actions:
u When a bit in the Operation NTR register is set to 1, then a 1-to-0 transition of the corresponding
bit in the Operation Condition register causes that bit in the Operation Event register to be set.
u When a bit of the Operation PTR register is set to 1, then a 0-to-1 transition of the corresponding
bit in the Operation Condition register causes that bit in the Operation Event register to be set.
u If the same bits in both NTR and PTR registers are set to 1, then any transition of that bit at the
Operation Condition register sets the corresponding bit in the Operation Event register.
u If the same bits in both NTR and PTR registers are set to 0, then no transition of that bit at the
Operation Condition register can set the corresponding bit in the Operation Event register.
Command Syntax
STATus:OPERtion:NTRansition<NRf>
STATus:OPERtion:PTRansition<NRf>
Parameters
0 to 32727
Preset Value
NTR register = 0; PTR register = 32727
Examples
STAT:OPER:NTR 32 STAT:OPER:PTR 1312
Query Syntax
STAT:OPER:NTR? STAT:OPER:PTR?
Returned Parameters
<NR1> (register value)
Related Commands
STAT:OPER:ENAB