Filter
Top Products
Chapter 16: SNMPv1 and v2c
194
Note
If you choose to use the default User and Group Names (ReadOnly
and ReadWrite) that are already displayed in the table, proceed to
step 7 below.
3. Type a new User Name.
Enter a name up to 31 characters in length.
4. Type a previously defined Group Name.
Enter a name up to 31 characters in length.
5. Select either v1 or v2c as the SNMP Version.
Note
The encryption check-box and Auth-Protocol, Priv-Protocol, and
password fields are intended for SNMPv3 configurations only and
are not used for SNMPv1 or v2c configurations.
6. Click Add.
See Figure 64 for an example of the SNMP User/Group page.
Figure 64. SNMP User/Group Page Example
7. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.
Modify User and
Group Names
If you need to modify an entry in the SNMP User/Group page, you must
first delete the entry and then re-enter it. For information about how to
delete an entry in this table, see “Delete User and Group Names,” next.