Filter
Top Products
Chapter 16: SNMPv1 and v2c
198
SNMP Traps
A Host IP address is used to specify a management device that needs to
receive SNMP traps sent by the switch. This IP address is associated with
the SNMP Version and a valid Community Name in the Host table of the
switch.
Create Trap Host
Table Entry
Use the following procedure to create a trap Host table entry:
1. From the main menu on the left side of the page, select the SNMP
folder.
The SNMP folder expands.
2. From the SNMP folder, select Trap Management.
The Trap Management Page is displayed. See Figure 67.
Figure 67. Trap Management Page
3. Enable trap management by selecting the radio button next to
Enabled at the top of the page.
By default, trap management is enabled.
4. Enter the Host IP Address for the management device that is to
receive the SNMP traps.
The IP address must be in the xxx.xxx.xxx.xxx format.
5. Enter the SNMP Version, either v1 or v2c, that is configured for the
host management device.
6. Enter a Community Name that you have defined previously in the
SNMP Community table.