Filter
Top Products
Page 2 - Start-Up Procedure
990-7167-001
Power Module Installation
1. Align the runners of a power module with the alignment grooves in the bottom module bay. Firmly slide the
power module into the frame until the “drop-lock” engages.
2. Swing the flip latch up and fasten the screw to the power module. Do not overtighten.
3. Follow this procedure to install all power modules.
n Power modules are installed on the left, battery modules are installed on the right.
n Always install power modules into the lowest available bay.
n If the power modules were installed at the factory, remove each of the shipping retainers that secured the
modules during shipping. Secure the flip latches.
Notice!