Filter
Top Products
Page 4 - The PowerView Interface - Appendix A
990-7169-001
The Startup Screen
The factory default startup screen is opened by pressing the escape key. It displays the following information:
n Fuel Percentage - the percentage of battery capacity (fuel) that is presently available.
n Load Percentage - the percentage of system capacity that is being used to supply conditioned power to
the load equipment.
n Voltage and Frequency - the input/output voltage, and the ouput frequency.
n Run Time - the run time that can be expected, based on the amount of power required by the load
equipment, and the power capacity of all battery modules connected to the Symmetra
TM
Power Array.
Note: The PowerView interface will “time out” after ten minutes of inactivity, and the LCD display will go blank. The
screen display will reappear when any key is touched.
Note: The startup screen for the international single phase models is depicted. Your startup screen may vary.
Top-Level Menu Screen
Press the escape key to open the “Top-Level Menu” screen. This screen is the “launching pad” to monitor, com-
mand and configure the system. Refer to the following tables for all PowerView commands and controls.
Note: The selection arrow in the illustration below is used to select a command. Pressing the up or down key moves the
selection arrow to the desired command, and then pressing the enter key opens it.