Filter
Top Products
Magnum XS 450 Power System –48 VDC User’s Manual Page 5
3 Installation
3.1. Unpacking Equipment
Remove equipment from packing material and inspect for shipping damage or missing items.
It is important to report damage or material shortages to the shipping carrier while a
representative is on site.
If concealed damage or material shortages are found at a later time, contact the shipper to
make arrangements for inspection and claim filing. Refer to
Section 7
in the event it is
necessary to return equipment to APC.
CAUTION
: Appropriate lifting techniques and safety equipment should be
used to remove equipment from packing.
PLEASE RECYCLE: The shipping materials can be recycled. Please
save them for later use or dispose accordingly.
3.2. Mechanical Installation
Room / Location
NOTE:
The APC Magnum XS 450 Power System is to be installed in a room, vault, or similar
enclosure that is accessible only to qualified persons in accordance with the local regulatory
authority.
Prior to installation, drawings, floor loading requirements, external alarm points, ac service
entrance, and grounding schemes should all be checked and confirmed. If batteries are to
be mounted in a room separate from the power plant, careful attention should be paid to
battery cable voltage drop effects. Environmental operating temperatures and
ventilation/cooling considerations should also be noted, not just for the power system but
also for all other equipment that may reside in the power room area.
The power system has a door on the front that can be hinged to swing either way. The
power system has two doors on the rear that swing out. The doors have spring loaded hinge
pins so that they can be removed for servicing. Dimensions are shown in Figure 3.2-1. The
sides have panels that are mounted flush with the frame. A key-lock on the top of the panels
holds the panels in place.