Filter
Top Products
Both lights blink.
m Paper may be jammed in the printer. Open the front cover and remove
any jammed paper. To advance paper that is part way through the printer,
press the resume button. Close the front cover and turn the printer off,
then on again.
m The ink-cartridge carrier may be jammed. Close the front cover, turn the
printer off, then on again.
The power light blinks, and the resume light is off.
m This is normal behavior when the printer is receiving data, printing, or
waiting for ink to dry.
The power light glows steadily, and the resume light blinks.
m One or both of the ink cartridges may not be seated properly, or you may
have forgotten to remove the tape from a new cartridge. Open the front
cover. Remove both cartridges. Holding the black plastic sides of the
cartridge, check to be sure the tape has been removed from the print head.
Then replace the cartridges in the carrier. Make sure each cartridge is
pressed all the way into the carrier. If a cartridge feels at all loose, it is not
properly seated. For instructions, see “Installing the Ink Cartridges” in
Chapter 1.
m The front cover may be open. Make sure it is closed.
m There may be no paper in the lower paper tray. Load paper and press the
resume button.
m The printer may need to be reset. Press and release the resume button.
Paper is jammed
Occasionally a piece of paper may get stuck inside the printer during the
printing process. To clear a paper jam, follow these steps:
1If necessary, open the front cover to see where the jam is.
2Gently pull the paper free.
3 To advance any remaining paper, press and release the resume button.
4 Turn off the printer, then turn it on again.
69
Troubleshooting