Filter
Top Products
Page 16
AsantéHub 2072 Network Management Module Installation Guide
The fourth configuration connects a terminal to an individual hub
using the RS232 connector as a local management port. The fifth
configuration connects an AMS to a single hub using one of the
hub’s AMS Link ports and an AMS Link Extender.
Figure 7 DIP switch settings for Local Management Port, and AMS
Link Extender with single hub
Connecting a Modem to
the Hub
For remote management purposes, you can make a local connec-
tion from the RS232 serial port on the NMM to a modem. You can
use this setup with AsantéView and the AsantéView Management
Station (AMS) to activate a pager when it receives a trap message
from a hub. This trap message causes the AMS to page this event to
the remote user. See the appropriate AsantéView User’s Guide for
information on setting up trap messages and paging options.
Straight-through RS232
Configuration 4
Configuration 5
Out-of-Band single hub
Local management port
12
12
AMS
AMS
12
12
12
only this device
is managed
Ethernet backbone
AMS Link Extender
Terminal
Hub Hub Hub Hub
Hub