Filter
Top Products
Page 21
Using Telnet
Using Telnet You can use Telnet to interrogate and program an AH2072 NMM
NMM with a NetStacker hub or AsantéHub
2072. You can do this
using any Telnet-capable computer, either directly connected to
the hub or over the network.
∆ Information on installing Telnet is not provided in
this manual. Refer to the documentation that
comes with the Telnet software.
The following list is a summary of the steps you need to perform
to use Telnet with an AH
2072 NMM connected to a NetStacker
hub or an AsantéHub
2072.
❏ Install the image code on the AMS
❏ Upgrade the hub’s image code
❏ Establish a link with the hub using Telnet
This procedure assumes you‘ve already done the following:
❏ Installed AsantéView In-Band or Out-of-Band soft-
ware on the AMS
❏ Connected appropriate cables for In-Band or
Out-of-Band management
❏ Set hub DIP Switches if needed
❏ Assigned an IP address to the hub
❏ Installed the Telnet application on your network
management station
Refer to the Telnet software documentation for installation
instructions. See the appropriate AsantéView User’s Guide for
information on installing and configuring the appropriate soft-
ware and hardware for using AsantéView.
Installing the Image Code Before you upgrade the image code in the AH2072 NMM with a
NetStacker hub or AsantéHub
2072, you need to install the image
code files on the AMS. Table 3 lists the files you need.
Table 3 Image Code File Names
AsantéHub 2072
2072huxx.17x or higher
2072h.cfg