Filter
Top Products
Installation
Page 2-4
Connecting
Power
To connect power to the IntraSwitch:
1
Plug one end of the supplied power cord into
the power connector on the back of the unit.
Figure 2-1 Connecting the power cord to the IntraSwitch
2
Plug the other end of the power cord into a
grounded AC outlet.
∆ Note: For more information about power
and environmental requirements, see Appendix C,
“Technical Specifications.”
3
Turn the power switch to the “on” position.
Make sure the IntraSwitch’s front panel LEDs
blink and the POWER LED lights and remains on.
▲ Important: If the power does not come
on, refer to Appendix A, “Troubleshooting.”
4
Turn the IntraSwitch’s power off.
The switch is ready be installed in an equipment
rack or prepared for desktop placement. See
the next section “Rack Mounting/Desktop Place-
ment” on page 2-5.