Filter
Top Products
Console Management
Page 5-34
Reset EEPROM to Default
This option resets the IntraSwitch’s values to the factory
default.
▲ Important: This procedure reverts all informa-
tion to the factory default settings except for
the switch’s IP address, subnet mask, and
default gateway.
See “Factory Defaults” on page 1-9 for a list of all
the switch’s factory default settings.
To reset the EEProm:
1
Type e from the Configuration Menu.
The following command line appears at the bot-
tom of the Configuration Menu:
Figure 5-13 Reset EEProm to Default command line
2
Type y to reset the EEPROM to default or N to
cancel the reset.
3
Reset the IntraSwitch by turning the switch off,
and then on again.