Filter
Top Products
Configure TCP/IP Parameters
Page 5-11
Configure TCP/IP Parameters
This menu displays and allows you to change the information
needed to access the IntraSwitch over the network (in-band
management).
To access the TCP/IP Parameter Menu, type i from the
Configuration Menu. The following menu appears:
Figure 5-4 TCP/IP Parameter Menu
∆ Note: By default, each parameter is set to 0.0.0.0.
Current Settings
Table 5-4 explains each setting on the TCP/IP Parameter
Menu.
For information on using the menu, see “Changing TCP/IP
Information” on page 5-12.
Table 5-4 TCP/IP Parameter Settings
Setting Description
Switch IP Address The IntraSwitch’s IP (Internet Protocol)
address.
Switch Subnet Mask The address of the subnet mask on which the
IntraSwitch is located.
Switch Default
Gateway
The address of the IntraSwitch’s default
gateway.
Current Settings