Filter
Top Products
Rack Mounting/Desktop Placement
Page 2-5
Rack Mounting/
Desktop
Placement
The IntraSwitch can be installed in most standard 19-inch
equipment racks. It can also be placed on a horizontal surface
with support capabilities of 11 pounds (5 kilograms).
Equipment Rack
Installation
To install the IntraSwitch in an equipment rack:
▲ Important: Disconnect all cables from the
switch before continuing.
1
Place the switch on a stable, flat surface.
2
Locate a rack bracket (supplied) and place it
over the mounting holes on one side of the unit,
as shown in Figure 2-2.
Figure 2-2 Mounting rack bracket on the IntraSwitch
3
Insert the four screws (supplied) into the holes
and tighten with a Phillips screwdriver.
4
Repeat the two previous steps for the unit’s
other side.
5
Place the IntraSwitch in the equipment rack.
▲ Important: Make sure the switch is sup-
ported until all four mounting screws for each
bracket are installed.
6
Secure with mounting screws.
The switch is ready to be connected to the network.
See “Connecting to the Network” on page 2-7.