Filter
Top Products
Console Management
Page 5-16
Configure SNMP Parameters
This menu controls the IntraSwitch’s SNMP (Simple Network
Management Protocol) parameters. With these parameters, you
can configure the switch’s read and write community strings,
set the switch to generate traps, and determine which
management stations on your network can receive traps.
To access the SNMP Parameter Menu, type n from the
Configuration Menu. The following menu appears:
Figure 5-6 SNMP Parameter Menu
Current Settings
Table 5-6 explains each setting on the SNMP Parameter
Menu.
For information on using the menu, see:
❏ “Changing Community Strings” — page 5-17
❏ “Enabling Traps” — page 5-18
❏ “Adding a Trap Receiver” — page 5-18
❏ “Deleting a Trap Receiver” — page 5-19
Current Settings