Filter
Top Products
ASUS MAXIMUS VII FORMULA
3-33
Chapter 3
SATA Express(SATAEXPRESS_1) and M.2 Configuration [Auto]
[Auto] The system will automatically detect the connected SATA Express or M.2
devices and set a higher priority for M.2 that SATA Express interface. The
connected device will then run at PCI-E mode rst than SATA mode. The
SATA devices are available when no SATA Express or M.2 devices are
installed.
[SATA Express] The bandwidth will be assigned to SATA Express(SATAEXPRESS_1) for
add-on devices with M.2 disabled.
[M.2] The bandwidth will be assigned to M.2 for add-on devices with SATA
Express(SATAEXPRESS_1) disabled.
SATA Mode Selection [AHCI]
This item allows you to set the SATA conguration.
[Disabled] Disables the SATA function.
[IDE] Set to [IDE] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[AHCI] Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
[RAID] Set to [RAID] when you want to create a RAID conguration from the SATA
hard disk drives.
The following item appears only when you set the SATA Mode Selection to [RAID].
Alternate ID [Disabled]
This item allows you to enable or disable Report alternate ID.
Conguration options: [Disabled] [Enabled]
Aggressive LPM Support [Disabled]
This item is designed for LPM (link power management) support with a better energy saving
conditions. When set to [Enabled], the hot plug function of SATA ports are disabled.
Conguration options: [Disabled] [Enabled]
S.M.A.R.T. Status Check [On]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks. Press <Enter> to set this item On or Off.
Conguration options: [On] [Off]