Filter
Top Products
5-36
Chapter 5: Driver installation
5.6 SCO OpenServer 5.0.6a
5.6.1 LSI
®
SCSI Driver Installation
A. Building the SCO OpenServer BTLD Diskette
To create a BTLD diskette for SCO OpenServer system, copy the raw dd
image file onto a 1.44MB floppy disk. This process is dependent upon the
operating system that you are using to create this diskette. See the
instructions below for UNIX System and DOS System Users.
Locate the SCSI files in the following path in the support CD:
\Drivers\SCSI\Fusion-MPT\SCO\1.03.17
For UNIX System Users:
Follow these steps to create the BTLD diskette:
1. Insert a 3.5" diskette into the floppy disk drive.
2. At the UNIX prompt, type:
dd if=/<path>/sco10317 of=/dev/fd0
The <path> represents the directory where you copied the dd image file.
This command will dd the image to the blank diskette to create a BTLD
diskette.
For DOS System Users:
1. Use a utility that will copy the raw dd image onto a 1.44 Mbyte
diskette. RAWRITE3.COM, which is a public domain utility, is
available. Instructions for using this utility are included in its
accompanying RAWRITE3.COM file.
2. The dd image is located in the zipped file you downloaded from the
LSI Logic web site.
3. RAWRITE3.COM is included within the zipped file. After the image
has been copied to a 3.5-inch diskette, use this BTLD diskette for
SCO OpenServer installations as instructed.