Filter
Top Products
ASUS PR-DLS533 motherboard user guide
5-37
B. New System Installation
This procedure installs SCO UNIX onto a hard disk drive. This installation
is necessary to build a new UNIX kernel that includes your SDMS driver.
During installation, you are given the option of retaining current partitions
on the root hard disk. For instance, you could have a DOS partition or a
user UNIX partition already established on the drive. For more details on
UNIX installation, refer to the SCO OpenServer Handbook.
1. Link the lsil BTLD into the UNIX kernel during installation.
2. Insert the SCO UNIX installation diskette and reboot the system. For
SCO OpenServer 5.0.6a, this diskette is labeled Boot Disk.
3. At the boot prompt, type
Boot
: link
Press Enter.
4. At the next prompt, type:
lsil
Do not remove the boot diskette. Press Enter.
5. When prompted during the installation, insert either the proper
installation diskette or the SDMS BTLD diskette, and press Enter.
The system may prompt you to enter a routine number:
“Please enter which routine (0-40) to replace ‘?’ to list, ‘a’ to add
“lsilinit” at the end [default], ‘n’ to do nothing, or ‘q’ to quit”
Enter the indicated routine number that precedes this message. Then
the system may prompt with another inquiry:
“Please enter which routine (0-2) to replace ‘?’ to list, ‘a’ to add
“lsilpoll” at the end [default], ‘n’ to do nothing, or ‘q’ to quit”
Enter the indicated routine number that precedes this message.
6. Continue the installation according to the SCO UNIX documentation.
7. The SCO OpenServer 5.0.6a system automatically creates a file,
unix.safe, during installation. To access this UNIX kernel, type after
the “boot:” prompt:
unix.safe
2. Install SCSI device support by continuing from “C. Existing System
Installation,” Step 3.