Filter
Top Products
ASUS PR-DLS533 motherboard user guide
5-5
B2. Boot Floppy Disk Installation
1. Have the driver diskette available for inserting into the A: drive when
prompted. Depending upon the media used to distribute drivers (web
or CDROM), you will create a driver diskette.
IMPORTANT: Read Step 2 before performing the instructions
contained within this step.
2. Start the Windows NT 4.0 installation by booting from the Microsoft
Setup floppy diskette.
3. Press Enter when the Welcome to Setup screen appears. The
Windows NT 4.0 Workstation Setup window appears next.
4. Press S to skip automatic detection and do manual selection. A
screen displays the message “Setup has recognized the following
mass storage devices in your computer...”
5. Choose S to configure additional adapters when a screen displays
the adapters found.
6. Move the highlight bar to Other and press Enter. The system prompts
for the manufacturer-supplied hardware support disk.
7. Insert the appropriate driver diskette containing the Windows NT
driver required to support your LSI Logic adapter(s) and press Enter.
8. “LSI Logic PCI SCSI/FC MPI MiniPort Driver” is shown highlighted.
Press Enter to proceed.
9. The Windows NT Workstation Setup window reappears. If using an
IDE CD-ROM for installation, press S to load additional drives.
Another window appears. Scroll up and select:
“IDE CD-ROM (ATAPI 1.2)/PCI IDE Controller”
Press Enter.
-or-
If you have completed configuring additional adapters, press Enter.
10. Upon exiting, a screen displays the message “Setup will load support
for the following mass storage devices(s). Press Enter to continue.”
This message implies that Windows NT recognizes the miniport
driver and the SCSI or Fibre Channel hardware.
At this point, simply follow the Microsoft Windows NT installation
procedure.