Filter
Top Products
ASUS RS100-E5-PI2 6-11
6.3 LSISoftwareRAIDConguration
Utility
The LSI Software RAID Conguration Utility allows you to create RAID 0 or RAID 1
set(s) from SATA hard disk drives connected to the SATA connectors supported by
the motherboard Southbridge chip.
To enter the LSI Software RAID Conguration Utility:
1. Turn on the system after installing all the SATA hard disk drives.
2. During POST, the LSI Software RAID Conguration Utility automatically
detects the installed SATA hard disk drives and displays any existing RAID
set(s). Press <Ctrl> + <M> or <Enter> to enter the utility.
LSI MegaRAID Software RAID BIOS Version A.05.090611342R
LSI SATA RAID Found at PCI Bus No:00 Dev No:1F
Device present at port 0 Hitachi HDS721616P 156554MB
Device present at port 3 Hitachi HDS721616P 156554MB
Press Ctrl-M or Enter to run LSI Software RAID Setup Utility.
-
3. The utility main window appears. Use the arrow keys to select an option
from the Management Menu, then press <Enter>. Refer to the Management
Menu descriptions on the next page.
At the bottom of the screen is the legend box. The keys on the legend box
allow you to navigate through the setup menu options or execute commands.
The keys on the legend box vary according to the menu level.
• The LSI Software RAID Conguration Utitlity auto congures to RAID 1
when the SATA to RAID Mode is enabled.
• The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
LSISoftwareRAIDCongurationUtilityVerA.53Sep06,2007
UseCursorKeystoNavigateBetweenItemsAndPressEnterToSelectAnOption
Management Menu
Congure
Initialize
Objects
Rebuild
Check
Consistency
CongureVD(s)